All components required to build your own Emergency Safety Light module.
When the power is removed it automatically switches to battery operation and illuminates the bright light emitting diodes.
The rechargeable battery enables the light emitting diodes to stay on independently for up to a minimum of three hours or until the electrical power returns.
R1 Resistor 270R Carbon Film Resistor 0.25W, Axial Leaded, 250 V
R2 Resistor 1k Metal Film Resistor 0.4W, Axial Leaded, 250 V
D5, D2, D1, D3, D4 1N4007RLG – AC to DC and stops 3.7v to base
Q S9012 PNP transistor in TO-92 package
C1 820nF (0.82uF) 250/400 volt AC capacitor – 400V 0.82uF Metallized Polyester Film Capacitor
C2 16v Capacitor Through Hole Capacitor 470 uF
F1 FUSE CF2470TT/3 3A Time Delay Micro Axial Fuse
D6 ZENER-DIODE 4.7V – 1N4732A
BAT Rechargeable Li-ion 18650 Battery 3.7V 2000mAh With Tabs AA
QC1 PCB for emergency light board 28.96mm x 23.37mm
LED COB/3w White COB Lamp DC 3V LED Panel Light 19mm x 19.5mm / 3v to 3.7v
5V Green power on LED
PCB mounted 3.5mm diameter test button for testing PCB LED strip.
Small enclosure for all the components to be installed into.
Components NOT supplied:
Solder for the components to the PCB board.
Glue for LED COB strip and PCB board / battery fixing in the small enclosure.
mains socket to install the kit into.
3 mm drill bit and drill for socket to install LED COB wires to socket back where PCB board is mounted.
I use a hot glue gun to fix the PCB board and battery.
Some basic knowledge of soldering and electronic circuits.
Want to purchase completed socket ready to install.
You can buy the complete module ready to install search this site for Emergency Light Module.